https://www.batna24.com/it/configurazione-unifi-layer3-routing
In this tutorial, we will show in a few steps the configuration of a simple Layer3 routing, based on UniFi switches. Naturally, keep in mind that not all UniFi switches support hardware support for L3 routing. In our case, we will perform the configuration based on the UniFi switch. USW-Pro-48-Poe. Below is a general diagram of our topology configuration.
Naturally, this is a conceptual configuration scheme, everything depends on the specific network topology. In our case, we rely on two Mikrotik CCR1036-8G-2S EM and, as I mentioned earlier, a switch UniFi USW-Pro-48-Poe.
The VLANs themselves, which we will create in our network, will be "native" to the ports to which they are assigned. That is, they will handle untagged traffic in relation to each other.
So, without wasting time, let's proceed with the configuration of our UniFi controller. We will present the configuration in a graphical form, which will be more readable and useful for a quick setup.
Let's start with the UniFi controller, on which we create new VLAN subnets.
For information: Ewa Smolińska – ewa@batna24.com – ph +39 392 268 40 71
